Phoenix simulator with the Esky ET61 6 ch.

Dragonfly118 · Charging Joined: 29 Apr 2010 Posts: 2 Location: Norfolk UK

Hello eveyone.I am new to 6 ch heli flying and I have an Esky HBK3 with the 2.4 tx.I have purchased a Phoenix sim to practice on before I attempt the real thing.All the calibrations have been carried out and the controls are working fine apart from the idle up. I can achieve idle up if I use a number key on the pc keyboard but I can't get it to work on the tx toggle switch.Has anyone else had this problem,and if so is there a solution?( The idle up works o.k on the real thing by the way).

tombo242 · Posted: Thu May 13, 2010 8:50 pm Post subject:

You should have "1 servo 90º" on your swash type setting for Pheonix to work properly. The CP mixing is done by the Pheonix engine.

Idle up/Normal works fine for me, but you MUST change settings if you switch from helis to planes.
_________________
Keep Smiling Smile

NMGeezer · Posted: Thu May 13, 2010 10:15 pm Post subject:

Hi Dragonfly,

I am not sure if the ET61 works thw same way, but I use the throttle/pitch curves set up in my DX6i.
You also have to uncheck the use prebuilt throttle curves for each model within phoenix.

Dragonfly118 · Charging Joined: 29 Apr 2010 Posts: 2 Location: Norfolk UK

Thanks guys,altered the 2 switches in the battery compartment and re-calibrated.Everything working as it should now.

3d flyer · Posted: Fri May 14, 2010 11:28 am Post subject: tombo

tombo u seem to be like dog shit on this forum.. lol.. everywere lol.. good to have an experienced heli man on hand cheers
luke
_________________
CENTURY KESTREL NITRO SE
ESKY HONEY BEE
WALKERA CB100

I bought the nitro kestrel first mabye i jumped in at the deepend ha ha getting there tho..