spektrum ar61100e and 3n1 cont.

sonnier00 · Posted: Sat Oct 01, 2011 9:23 am Post subject: spektrum ar61100e and 3n1 cont.

if the green on the 3n1 is steady the cont. should be good right ? I'm sure I must have broke the board on the RX in my big wreck. One of the motors run full blast when I plug a battery in. It went bad in mid air on broke parts just question.
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

sonnier00 · Posted: Sat Oct 01, 2011 9:35 am Post subject:

Also can I replace the ae6100e with a ae6110e?
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

pjdog · Posted: Sat Oct 01, 2011 10:13 am Post subject:

Yes

I assumed you are talking about a Spektrum AR6100E receiver with a Spektrum AR6110E receiver.
_________________
RC Submarines (3)
RC Planes (20)
RC Boats (3)
RC Helicopters (5) B400-EXI 450 pro-EXI 450-MSR-MCX
DX6I (2)
AMA-952547

sonnier00 · Posted: Sat Oct 01, 2011 11:04 am Post subject:

Yes that's right.
Do you know any thing about my 3n1 problem? In plug a battery in with on RX connected and the motor still runs. Could it be that with on RX it could be stuck in the run mode
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

pjdog · Posted: Sat Oct 01, 2011 9:32 pm Post subject:

I'm going to assume that you have the throttle stick all the way down. The motor keeps running anyway.

So I I'll assume that you must of had a crash and the throttle stick was not closed before you hit the ground.

When the power (throttle) is on and the rotor blades can not move because of a crash it can cause a power surge in the Electronics. This will cause an electronic failure. Strange things can happen when this happens. I put a fuse on my old Exceed Falcon 40 V2 to avoid this problem. The fuse would pop rather than the 4-in-1. Now I just close the throttle when a crash is going to happen. The helicopter is going to get messed up so just accept it and shut down what you can.

My guess is you need a new 3-in-1? But I really don't know enough of what has happened or what is working and what is not working.

So it's just a guess. If you going to play with RC helicopters your going to need to do repairs because we all crash. Even the best pilots crash.

Jack
_________________
RC Submarines (3)
RC Planes (20)
RC Boats (3)
RC Helicopters (5) B400-EXI 450 pro-EXI 450-MSR-MCX
DX6I (2)
AMA-952547

pjdog · Posted: Sat Oct 01, 2011 9:32 pm Post subject:

ooop's
_________________
RC Submarines (3)
RC Planes (20)
RC Boats (3)
RC Helicopters (5) B400-EXI 450 pro-EXI 450-MSR-MCX
DX6I (2)
AMA-952547

sonnier00 · Posted: Sun Oct 02, 2011 1:15 pm Post subject:

Jack I was flying when it happen. I had bad wreck weeks before. I thank I danaged the rx then. When it hit the ground the motor was hung up before it hit. I still thank the rx was bad and went south in the air. This weck was not that bad. Like heat or vabration finshed off
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

pjdog · Posted: Sun Oct 02, 2011 8:59 pm Post subject:

Yea - You most probably cooked the 3-in-1.

They easy to replace. The cost can sometimes out weigh the thought of replacement or just get a new helicopter.

I hate to scrap anything. I like to repair things so I would go for it and get another 3-in-1.

jack
_________________
RC Submarines (3)
RC Planes (20)
RC Boats (3)
RC Helicopters (5) B400-EXI 450 pro-EXI 450-MSR-MCX
DX6I (2)
AMA-952547

sonnier00 · Posted: Mon Oct 03, 2011 9:22 am Post subject:

I know what you mean about scraping any thing if can be fixed. I'm to deep into up grades now. Besides ebay do you know any places to look for parts?
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

pjdog · Posted: Mon Oct 03, 2011 9:04 pm Post subject:

Hey Sonnier:

Anything that is Blade (E-Flite) you can get parts at Horizion hobby.
www.horizion.com. But they will be the most expensive, However they always have the parts and have a great tech phone line support.

A search on the internet may help you find spares. Sometimes I get spares from China at a greatly reduced price. But then there is a long wait time for delivery.

Good luck in your search.

Jack
_________________
RC Submarines (3)
RC Planes (20)
RC Boats (3)
RC Helicopters (5) B400-EXI 450 pro-EXI 450-MSR-MCX
DX6I (2)
AMA-952547

sonnier00 · Posted: Thu Oct 06, 2011 9:02 am Post subject:

Jack, You was right about the 3n1 cont. I received the new RX and plugged in the 3n1 bounded the RX. and nope the 3n1 did not reset. I had order the 3n1 cont. should be in any day now.
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

sonnier00 · Posted: Thu Oct 06, 2011 11:54 pm Post subject:

Jack
I like to fix things also. So I looked into the bad 3n1 cont. What I found was the SS24 rectifier had blown. I found someone on ebay that sales them in lots less then 100 (i need one) the seller is in the UK all total $5.50 for two including shipping. I going to try and fix this one and have a spare cont.. I'll let you know the out come.
_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3

pjdog · Posted: Fri Oct 07, 2011 12:04 am Post subject:

Looking forward to hearing how it works out>

jack
_________________
RC Submarines (3)
RC Planes (20)
RC Boats (3)
RC Helicopters (5) B400-EXI 450 pro-EXI 450-MSR-MCX
DX6I (2)
AMA-952547

tombo242 · Posted: Fri Oct 07, 2011 4:00 am Post subject:

Yeah - me too!

Tom.
_________________
Keep Smiling Smile

sonnier00 · Posted: Fri Oct 07, 2011 6:43 am Post subject:

dose not soud like a high vote of confidence Very Happy

_________________
Nathan Sonnier
A good flying day is to at least have something to bring home and fix.
Blade CX3