I used a Turnigy RC Electronic Switch to control a DrMad Audio Board and DRMad Lighting board & Speaker, these are powered by a separate 3.7 LiPo, the guns I removed the barrels supplied and replaced them with CF tubing and ran the wires from the LED through the center back into the cockpit, I then covered the barrels with shrink sleeve to restrict the light to the very end of the barrel, 2 small LED (50 Cal) and 1 large LED (20mm Cannon).
Joined: 20 Mar 2009 Posts: 1101 Location: Brisbane, Australia
Posted: Mon Mar 17, 2014 3:38 pm Post subject:
Here you go, nothing else required except the ability to read Chinese instructions, give me a shout if you need help, the only problem I had was working out you need a common negative between the two batteries if you go that way.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum