| View previous topic :: View next topic |
| Author |
Message |
Carryion
Hover Master
Joined: 21 Sep 2007
Posts: 8
Location: North Alabama
|
 Posted: Sun Sep 30, 2007 5:55 am
Post subject: A few question |
 |
|
Ok Got my Flybar on my EK005 ESky Honey Bee Mk 3 And i finley after a few ajusments its loosk good to go. I could not get it to hover, No matter what I tryed.
It flys level, But it shifts to the left. It dont turn any right to left but the hole helic noves left
I went to my books and manual but it wants me to move a small ajustment to the left, ( But this is talking about the Tail roter. ) The hold hole Heli moveing left. I Figers its just a small ajustment on Servo Push Rod. Any comments or sugestions are welcome |
|
| Back to top |
|
 |
vrthai
Extreme 3D
Joined: 03 Aug 2007
Posts: 188
|
Posted: Sun Sep 30, 2007 9:22 pm
Post subject: |
|
|
|
I think you should try to adjust the linkage on the main rotor swash plate. It looks like when you put the flybar back in, the linkage is out of tune... |
|
| Back to top |
|
|
rex123
Hopping Maniac
Joined: 20 Sep 2007
Posts: 21
|
Posted: Sun Sep 30, 2007 11:16 pm
Post subject: |
|
|
Um sounds to me like you might not have put the parts back together properly. Maybe check the manual over again and make sure.
The linkage shouldn't have gone off if you never adjusted it. |
|
| Back to top |
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
SmartFeed
Album
