lama v4 4 in 1 wont bind or something

thedodd · Flying Inverted Joined: 08 Dec 2007 Posts: 61

when i turn on the tx and receiver the light just blinks red and nothing responds. any ideas?

silhouette015 · Posted: Sun Nov 30, 2008 1:35 am Post subject:

sorry for the slow reply. But can you describe the symptom a bit further?

PatfromMN · Posted: Thu Dec 31, 2009 3:53 am Post subject: Binding issues

I am having similar problems with a Lama V4. I tried following the instructions, and here's what I am seeing.

the LED on right side blinks continously.

The LED on the left side starts by blinking red twice, and then blinks alternately green and red.

I've tried repeating the binding process described in the manual, several times, but I haven't had much success.

Any suggestions?

Pat

Naev · Hopping Maniac Joined: 30 Jun 2010 Posts: 45

I got this problem too... subscribe

tombo242 · Posted: Thu Jul 29, 2010 5:17 pm Post subject:

Your right led should stop flashing and go steady when the Rx locks. If the Tx signal is poor, then the Rx cannot lock and the light will keep flashing.

Your left led is showing ESC lock and battery voltage. The lock led shows green when the battery voltage is high enough for flight. It then goes red when the battery voltage drops to around 3.1V under load. You should land as it flickers red and change batteries. As yours is not getting off the ground yet, that part is information only.

Make sure that your batteries are good. One poor one in the Tx will reduce the signal to the point where the Rx cannot lock to it. Your flight battery should also be checked as low voltage may well effect the Rx lock.