| View previous topic :: View next topic |
| Author |
Message |
magyarbacsi
Extreme 3D
Joined: 04 Aug 2011
Posts: 99
Location: seattle
|
 Posted: Fri Aug 05, 2011 2:55 am
Post subject: re Hobbyking EC135 |
 |
|
I think I resolved the control board Issue. Art-Tech MD 500 uses the same board, on sale for $17. I did not get a manual from hobbyking, as I found out most customers don't either. I know how to bind rx to Tx as I have with my other copters. On the EC135, extending from the copter is a 3 wire plug, beside the two battery connectors. It is like all servo plugs. Also included in the box was a small jumper wire that obviously fits into the 3 wire (blk, wht, red ) plug. I have no clew as to what to and when to use the jumper wire. If used, it would connect the blk to white wire and wire comes from the 6 channel receiver marked battery.
Any suggestions? |
|
| Back to top |
|
 |
platinum
Extreme 3D
Joined: 31 May 2011
Posts: 272
Location: Bangkok Thailand
|
Posted: Fri Aug 05, 2011 4:04 pm
Post subject: Re: re Hobbyking EC135 |
|
|
| magyarbacsi wrote: | .... Also included in the box was a small jumper wire that obviously fits into the 3 wire (blk, wht, red ) plug. I have no clew as to what to and when to use the jumper wire. If used, it would connect the blk to white wire and wire comes from the 6 channel receiver marked battery.
Any suggestions? |
When binding process, insert the jumper to the Bat port of the receiver.
I don't know exactly what's yours look like but you right it for battery port.
platinum
_________________
/Goal : relaxed flying with the least fixing. 
 |
|
| Back to top |
|
|
magyarbacsi
Extreme 3D
Joined: 04 Aug 2011
Posts: 99
Location: seattle
|
Posted: Fri Aug 05, 2011 10:50 pm
Post subject: Big Lama EC 135 |
|
|
|
Platinum, thank you. |
|
| Back to top |
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
SmartFeed
Album
